FLASHFORGE 3D PRINTER Dreamer NX User Manual page 51

● Temperature Control: Input the temperature you want to get in the left
frame, click [Apply], the printer will automatically heat the corresponding part,
the right side shows the current actual temperature of corresponding part. After
start heating, the below curve of temperature form will start to change, different
color correspond with different parts' temperatures
Update Firmware
②
Every time when you start FlashPrint, it will automatically detect and download
the up-to-date firmware. If any update is available, a dialog box will pop up for
reminding the users to update.
Step 1: Click [Tools]--[Update
before updating firmware. If software and printer are already in connection, it
will remind you cutting off the connection. Then choose
next step.
Step 2: Choose corresponding printer type and firmware version and click
in the firmware updating box. After confirming the printer is in free state, the
software will automatically update the firmware.
Step 3：Reboot you Dreamer NX and wait for 4-5 seconds, then you can see
the update process bar. When the update finishes, it will go back to the main
interface.
Step 4：Tap [Tools]--[About]
On Board Preferences
③
When the computer and printer are in connection, click
Preferences], you can check the printer name.
Machine information
④
When the computer
[Tools]--[Machine
name and firmware etc.
Dreamer NX User Guide | www.flashforge.com
firmware]. It needs to cut off connection
to check whether the updated version is right.
and printer
information], you can check the machine type, machine
[Yes]
[Tools]--[On Board
are in connection
and go on to the
[OK]
state, click
52