FLASHFORGE 3D PRINTER Dreamer NX User Manual page 39

Auto Supports
②
Click the [Auto Supports]
supports are needed and generate corresponding treelike or linear supports. If
it is a model with supports, the existing supports will be deleted and new
supports will be generated.
Add Supports
③
Supports will be added once clicking the
position where supports needed, left-click to choose the starting point of
supports, hold down the left mouse button and drag the mouse, the supports
preview will show up (if support surface doesn't need support or the support
column angle is too large, the support review will be highlighted).Loosen the
left mouse button, if support column doesn't meet with model, then support will
be generated on origin and terminal point (the highlighted preview support
Dreamer NX User Guide | www.flashforge.com
6-12
button, the software will judge the position where
[Add] button. Move the cursor to the
40