FLASHFORGE 3D PRINTER Dreamer NX User Manual page 41

⑦ Brim: Expand the outline of model's bottom layers to a Brim which helps
anchor the edges of the model to the plate to avoid warping.
⑧ Resolution ： You have three resolution solution (with default setting) to
choose from, high resolution is corresponding with slow printing speed,
opposite for the low resolution. For PLA printing, an extra solution "Hyper" is
available.
⑨ More options: Click
temperature. Different resolution solution is corresponding to different defaults,
click [Restore Defaults]
●Layer
a. Layer: Layer thickness of the printing model. With a small value, the
surface of the model will be smoother.
b. First Layer Height: This is the first layer of the model, which will affect
the sticking performance between the model and platform. Maximum is 0.4mm,
usually the default is OK.
c. Shell: Contains the outside shell value, capping layer value (under
vase pattern, top solid layer setting is invalid.)
● Perimeter Shells: Maximum is 10
a. Top Solid Layer: Maximum is 30, minimum is 1.
b. Bottom Solid Layer: Maximum is 30, minimum is 1.
● Infill
a. Fill Density means fill rate.
b. Fill Pattern is the pattern of filling shape which effects printing duration.
c. Combine Infill: You can select the layers for combining according to
the layer thickness. The combined thickness should not exceed 0.4mm. "Every
N layers" is for all the infills while "Every N inner layers" is only for inner infills,
Dreamer NX User Guide | www.flashforge.com
[More options] to set for layer, shell, infill, speed and
to back to default setting.
42