Power Saving; Video Out; Display Status - Barco MDSC-8527 Series User Manual

Advanced operation

4.5.2 Power saving

About power saving
When the selected input(s) is (are) missing (main, 2nd and failover), this setting allows the display to switch off
the backlight and enter a low power mode. As soon as the selected input(s) is (are) present again, the display
will exit the power save mode and display the image. Also, by activating the OSD menu, the display will exit
power save mode.
The available options are:
• Off
• 5 min
• 30 min
• 60 min
When the Auto search function is enabled (see
the power save mode, even when the input(s) is (are) missing.
To enable/disable power saving
1. Bring up the OSD main menu.
2. Navigate to the System menu.
3. Enter the Power Saving submenu.
4. Select one of the available options and confirm.

4.5.3 Video out

About video out
This setting allows to enable or disable the Video output function of your display. Enabling Video output will
copy the Main Source (only in case of DP SST, HDMI-1, HDMI-2, 4K-SDI) to the DisplayPort 1.2 SST output.
To enable/disable video out
1. Bring up the OSD main menu.
2. Navigate to the System menu.
3. Enter the Video output submenu.
4. Enable/Disable Video out as desired and confirm.
Video out is always disabled when the Main Input = DP MST.

4.5.4 Display status

About display status
This information shows the active values of the main display parameters.
To consult display status
1. Bring up the OSD main menu.
2. Navigate to the System menu.
3. The display status information is shown.
38 R5914634 /01 MDSC-8527
"Main source", page 30), the display will not enter