Mdsc-8527 12Gp Version - Barco MDSC-8527 Series User Manual

5. Connect the USB2.0 type B interface to a USB memory stick for in-field firmware updates. For more
information, please refer to qualified service personnel.
Image 2–2
DisplayPort VESA DP 1.2 certified cables for 5.4 Gbps HBR2 with a length of up to 3 m are
recommended.
Premium certified HDMI 2.0 cables with a length of up to 3 m are recommended.
Use 3G-SDI Belden 1694A cables with a length of up to 50 m.
The video output must be enabled in the OSD menu (see
A subset of the commands of the remote control protocol is also available on a new DDC protocol
on DVI and DisplayPort1 auxiliary channel.

2.2.2 MDSC-8527 12GP version

To connect the interfaces
1. Connect one or more video source(s) to the corresponding video inputs of the display. For a list of
supported video inputs, see
2. SDI input loop-through: When the SDI video input is connected, an additional SDI video sink can be
connected to the SDI output.
3. Video output: The entire active image on the screen (including OSD) can be duplicated to a FHD (1080p/
1080i) signal on the DisplayPort output connector, to which an additional DisplayPort video sink can be
connected.
4. Connect the USB2.0 type B interface with a workstation to use the remote control protocol.
5. Connect the USB2.0 type B interface to a USB memory stick for in-field firmware updates. For more
information, please refer to qualified service personnel.
6. 4 BNC connectors available for Quad-link SDI or 2x 12G-SDI In and 2x 12G-SDI Out.
2
"Technical specifications", page
Display installation
1 3
"Video out", page 38).
56.
R5914634 /01 MDSC-8527
4 5
15