Powering The Base Unit; Battery Installation - Viavi ONA-800 Getting Started Manual

Chapter 1 Getting started

Powering the base unit

Powering the base unit
Power is supplied to the instrument by the battery or the AC power adapter. For the
ONA-800, the adapter is supplied with the instrument. Use of AC power adapters or
batteries other than those supplied with your ONA-800 is not recommended as other
slices/modules may be supplied with incompatible adapters or batteries. When
supplying power using AC power adapter, you need to verify that you have the correct
adapter.

Battery Installation

The base unit can operate supplied by the AC power adapter shipped with the unit or
by battery.
Figure 12 ONA-800 battery label
Page 12
CAUTION:
Do not attempt to run the ONA-800 in an enclosure such as the soft-shell travel
case. Doing so may damage the unit.
Figure 12 shows the battery label.
CAUTION:
The Lithium Ion batteries shipped with the unit can explode if incorrectly
installed. When replacing the battery, ensure that you only use VIAVI approved
battery types, as shown in Figure 7, and that they are properly installed. Always
dispose of batteries according to your local safety and environmental
regulations.
NOTE:
VIAVI recommends that you either power off the unit or switch to AC power
before replacing the batteries.
ONA-800 Getting Started Guide
22142812, R011 April 2022