Expansion Modules - Viavi ONA-800 Getting Started Manual

Chapter 1 Getting started
Attaching components
2
Place the unit so that you have access to the back and remove the termination
cover by removing the screws that hold it in place.
3 Set the module onto the screen, ensuring the mating connectors between the two
pieces are aligned, as shown in
Figure 8
4 Insert the hex key in the brass fittings on the rear of the module and tighten the
internal captive fasteners to secure the module to the display.
5 Place the ONA-800 base onto the module, ensuring the mating connectors are
aligned, as shown in
Figure 9
6
Using the hex key, tighten the captive fasteners on the rear of the base that
secure it to the module.
7 Re-attach the expansion modules or back cover.

Expansion modules

You can attach the following expansion modules to the ONA-800:
Page 8
Module to screen
Figure 9.
ONA-800 base to module
ONA-800 Getting Started Guide
22142812, R011
Figure 8.
April 2022