Advertisement
Commercial model operating guide
Turn on the steam generator by pressing the ON/OFF button on the main controller on the steam generator which in turn will begin to heat up the water.
Once 80°C has been reached the steam generator will be in standby mode, ready for use.
When the fast steam button is pressed, steam will be produced in approx. 30 seconds. After 30 minutes, the system will revert back to "stand by" and
steam will stop being produced. Simply press the button again to activate the steam or stop it at any time.
Advantages:
This design saves consumers' waiting time, as well as also saving energy.
The 30 minutes automatic 'back to stand by status' design would prevent energy waste caused by the owner or customers forgetting to turn off the steam
generator after use.
The fast steam button is designed to be installed inside the steam room so users can reactivate easily if they wish to continue their steam session after
automatic shut off after 30 minutes.
If the steam session time is less than 30 minutes, it can be back to set back to 'stand by' status manually by pressing the button and switching off the
steam.
•
Once the "fast steam" mode is activated, the steam generator will go into "commercial
mode" and the controller will show "commercial mode" and the remaining working time.
The time counts down from 30 to 0.
•
Once 30 minutes runs out, it will revert back to stand by (Heat preservation state).
www.insigniashowers.com
Last Modified: 06/05/2022
31
Advertisement
