Advertisement
Installation of the Salt Spray Generator
The generator is able to atomize salt water into tiny particulates
and mix in the air for breathing and absorbed by skin, this is good
for health.
A.
Power supply: AC110-240V
B.
Spray head working voltage: 36V
C.
Working Current: 880mA
D.
Rated Power: 20W±5
E.
Ultrasonic frequency: 1.7MHz±10%
F.
Maximum spray rate: ≥3mL/min
G.
Spray particle diameter: 5μm ≥65%
H.
Noise: ≤10dB
I.
Two full bottles of salt water can continuously atomise for 2-
4 hours. The complete model, connected to the signature
steam generator can set a working time, spanning from 1-60
minutes, or be set to run continuously. Once the salt is used
up, it will stop functioning automatically. The independent
model requires manual activation and deactivation, with no
time able to be set.
J.
For an independent installation of the salt spray generator,
skip steps 1 & 2 (right).
K.
The salt spray generator MUST be installed vertically, never
install horizontally as this unit will not work. This should be
installed inside the steam room at a height above a bench
that allows users to sit comfortably under it with a clearance
of approx. 300mm.
L.
Salt spray generator central box should be installed in a dry
place, do not install in the steam room.
www.insigniashowers.com
Salt spray generator central box
1
2
1.
Connect the steam generator central box to the salt spray generator
central box — DC connector 1.
2.
Connect the last coloured light in the circuit to the salt spray generator
central box — DC connector 2.
3.
Connect the salt spray generator to the salt spray generator central
box — DC connector 3.
4.
Connect power using the power adaptor.
Last Modified: 06/05/2022
1.
Salt Spray input signal
2.
Colour lights input signal
3
4
3.
Salt spray Generator input signal
4.
Power input
25
Advertisement
