Advertisement
Functions and Operations—Salt Steam Generator
Attention:
•
Do NOT turn on the salt spray generator if there is no salt water in the bottles.
•
The generator central box must not be installed in areas that are highly acidic, high in moisture, explosive or flammable.
•
Do NOT rotate the head of generator or take apart when it is working.
•
Do NOT put your fingers into the generator.
•
Do NOT block the cap's vent and drain hole.
•
It's recommended you use softer water to prevent scaling and prolong the life of the unit.
•
The spray head of the salt generator is preset with a "lack of water" protection function. If the generator stops working through a lack of
water, turn the system off and back on again before refilling with water.
•
In the event of a malfunction, we strongly advise against disassembling the unit yourself.
•
The salt spray generator should be out the reach of children to avoid any accident.
Filling the bottles with salt water
Remove the glass bottles from the salt spray generator. Unscrew the cap, fill up with the saltwater solution, screw the cap on and replace the bottle
in position. It is normal for a small amount of leakage when the bottle is being replaced. Once replaced, the salt reservoir will start to fill until it
reaches the bottle level.
Do not use a high concentration of salty water, you should dilute according to your personal preference. Our suggestion is to mix 9g salt to every
1000ml water.
Maintenance:
The salt water container and spray head should be washed with fresh water every week.
The end cover of the generator should NOT be washed directly with water, instead wipe with a clean wet towel. Do NOT wash it with alcohol,
chemicals or hot water.
When not in use for a long time, the remaining water should be poured out and disposed of safely.
www.insigniashowers.com
Last Modified: 06/05/2022
26
Advertisement
