Advertisement
www.insigniashowers.com
Last Modified: 06/05/2022
Accessories Installation: Aroma Pump
Locate the aroma pump system to somewhere you can easily monitor the consumption of essential oils and for easy oil replacement.
The aroma pump system is designed and intended for indoor use only, should be located indoors in a dry clean location and not subject
to moisture, condensation or similar high humidity environments. The aroma oil container should be fixed onto a secure vertical surface.
Hang the aroma pump on two screws with a distance of 215mm, and 1.5m above the ground.
Do not install aroma pump systems outdoor or in a location where water could freeze.
Do not install aroma pump systems near flammable or corrosive materials and chemicals.
Install the aroma pump system in an easily accessible location, which could provide access for maintenance and refills.
The system should NOT be installed in areas accessible to children. It is strongly recommended to install the system in a separate room.
The aroma pump system output MUST be higher than the ¾'' Injection pipe, but the height difference should not exceed 1.5m.
Isolated to Heat Sources:
Do not install the aroma pump system directly below or above the steam generator where it is subject to heat.
Minimum distance between the aroma pump system and steam generator MUST be 0.5m (500mm)
Ambient temperature at and around the Aroma pump system should not exceed 32°C, because the oil needs to be stored in a cool place.
Installing the aroma oil injection:
For installation on a ¾'' steam output pipe, connect the steam pipe line to the ¾'' Injection pipe directly.
For installation on a ½'' steam output pipe, use a ½'' to ¾'' converter between the steam pipe and ¾'' injection pipe
The ¾'' injection pipe should be within 2.5 meters from the steam head, and note that the ¾'' injection pipe should be
installed vertically, this will prevent the aroma oil flowing back towards the steam generator.
Use PTFE tape on the threads for a better seal.
21
Advertisement
