Table of Contents
Advertisement
6. Hang on the cooker hood on to the two screws
previously installed.
around the required height (Fine adjustment
can be done later. Then install plate I on
the chimney using two screws (4mm x
8mm). Only tighten the screws loosely to
allow the chimney height to be adjusted.
7. If venting externally attach the vent pipe onto the one-way-
valve, and fix the pipe on the valve using the cable tie. The
adaptor can be used at this stage, if you already have existing
smaller diameter venting in place to connect.
8. Adjust the length
of the chimney to
9. Fix the base of the chimney to the hood with 2 x
Screws (4mmx8mm), then fix plate I to wall with 2 x
screws (4mm x 40mm), before routing the vent
pipe to the outside. (If Recirculating no vent pipe is
required, and the air will be expelled through the
vent holes in the side of the upper chimney)
9
Advertisement
Table of Contents
