Steps
1. Route the antenna cables through the routing guides on the chassis.
2. Align and place the screw holes on the WLAN antenna with the screw holes on the chassis.
3. Replace the two screws (M3x5) to secure the WLAN antenna to the chassis.
Next steps
1. Install the
hard-drive and optical-drive
2. Install the
WLAN
card.
3. Install the
3.5-inch
hard-drive.
4. Install the
2.5-inch
hard-drive.
5. Install the
front
bezel.
6. Install the
side
cover.
7. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
hard-drive and optical-drive
NOTE:
Removing the coin-cell battery resets the BIOS setup program settings to default. It is recommended that you note
the BIOS setup program settings before removing the coin-cell battery.
cage.
after working inside your
before working inside your
bracket.
computer.
computer.
Removing and installing components
37