Dell Precision 3460 Small Form Factor Service Manual page 77

Steps
1. Align and lower the system board into the system until the stand-off points at the back of the system board align with those
on the chassis.
2. Replace the five screws (#6-32) to secure the system board to the chassis.
3. Connect all the cables to the respective connectors on the system board.
4. Align and place the I/O panel into the slot on the chassis.
5. Replace the screw (#6-32) to secure the I/O panel to the chassis.
Next steps
1. Install the processor.
2. Install the heat-sink and fan
3. Install the expansion card.
4. Install the WLAN card.
5. Install the solid-state
6. Install the memory modules.
7. Install the hard-drive and optical-drive
8. Install the 3.5-inch hard-drive.
9. Install the 2.5-inch hard-drive.
10. Install the front bezel.
11. Install the side cover.
12. Follow the procedure in
assembly.
drive.
cage.
after working inside your computer.
Removing and installing components 77