Power Button; Removing The Power Button - Dell Precision 3460 Small Form Factor Service Manual

Steps
1. Insert the rubber grommets on the chassis.
2. Align the slots on the fan with the rubber grommets on the chassis.
3. Route the rubber grommets through the slots on the fan and pull the rubber grommets until the fan snaps into position.
4. Connect the fan cable to the connector on the system board.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in

Power button

Removing the power button

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch
5. Remove the 3.5-inch
6. Remove the hard-drive and optical-drive
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
62 Removing and installing components
after working inside your
before working inside your
hard-drive.
hard-drive.
cage.
computer.
computer.