Removing The 3.5-Inch Hard Drive - Dell Precision 3460 Small Form Factor Service Manual

Steps
1. Align the pins on the caddy with the slot on the hard-disk drive and insert the hard-disk drive into the caddy.
2. Pull the other end of the hard-disk drive caddy and insert the hard-disk drive into the slot.
3. Align the tabs on the hard-drive assembly with tabs on the chassis.
4. At an angle insert the hard-drive assembly into the slot on the chassis.
5. Press the hard-drive assembly down till it clicks in place.
6. Connect the hard drive data and power cables to the connectors on the hard drive.
Route the cable through the recess on the release latch.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in

Removing the 3.5-inch hard drive

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
20 Removing and installing components
after working inside your
before working inside your
computer.
computer.