Figure 42. Installing the speakers
Steps
1. Using the alignment posts and rubber grommets, place the speakers on the slots on the display-assembly base.
2. Route the speaker cable through the routing guide on the display-assembly base.
3. Connect the speaker cable to the system board.
Next steps
1. Install the
system-board
2. Install the
I/O
cover.
3. Install the
back
cover.
4. Install the stand.
5. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
5. Remove the
system-board
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
68
Removing and installing Customer Replaceable Units (CRUs)
shield.
After working inside your
Before working inside your
shield.
computer.
computer.