Installing The Processor Fan And Heat-Sink Assembly - Dell Precision 3460 Small Form Factor Service Manual
Hide thumbs
Also See for Precision 3460 Small Form Factor:
- Setup and specifications (23 pages) ,
- Service manual (99 pages)
Table of Contents
Advertisement
Steps
1. Disconnect the processor-fan cable from the connector on the system board.
2. In the reverse sequential order (4->3->2->1), loosen the four captive screws that secure the processor fan and heat-sink
assembly to the system board.
3. Lift the processor fan and heat-sink assembly from the system board.
Installing the processor fan and heat-sink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the processor fan and heat-sink assembly and provides a visual representation of
the installation procedure.
Removing and installing components
55
- Quick Links:
- Memory
- Installing the Memory
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Precision 3460 Small Form Factor and is the answer not in the manual?
Questions and answers