Daikin Floor Standing Type F-Series Service Manual page 77

SiBE06-708_A
Airflow selection
• Make airflow selection according to what suits you.
When setting the airflow selection switch to
•
Air conditioner automatically decides the appropriate blowing pattern depending on the operating
mode/situation.
Operating mode
COOL mode
HEAT mode
During Dry mode, so that cold air does not come into direct contact with people, air is blown
•
upper air outlet.
When setting the air outlet selection switch to
• Regardless of the operating mode or situation, air blows from the upper air outlet.
• Use this switch when you do not want air coming out of the lower air outlet. (While sleeping etc.)
CAUTION
• Do not try to adjust the flap by hand.
• When adjusting by hand, the mechanism may not operate properly or condensation may drip
from air outlets.
Operation Manual
Situation
•
When the room has become fully
cool, or when one hour has
passed since turning on the air
conditioner.
•
At start of operation or other
times when the room is not fully
cooled.
• At times other than below.
(Normal time.)
• At start or when air temperature
is low.
.
Blowing pattern
•
So that air does not come into
direct contact with people, air is
blown upper air outlet, room tem-
perature is equalized.
• Air is blown from the upper and
lower air outlets for high speed
cooling during COOL mode, and
for filling the room with warm air
during HEAT mode.
• So that air does not come into
direct contact with people. Air is
blown upper air outlet.
.
Operation Manual
13
66