Yamato Just NAVI J-101W Operation Manual page 18

Chapter 4 User parameters
No.
#39 Scale interval threshold for the
automatic tare function
You can set scale intervals to detect
a valid tare for the automatic tare
function.
#163 Unit of the lower limit for easy
setup
You can set scale intervals or a ratio
(%) as the unit of the lower limit for
the easy setup. Set the value in
#164.
#164 Value of the lower limit for easy
setup
You can set the value of the lower
limit for the easy setup. Set the unit
in #163.
#165 Automatic set time for the lower
limit of easy program setting
You can set the time after which the
value entered with numeric keypad
is registered as the lower limit of
easy program setting. You can also
disable the automatic set time.
#166 Fixed weighing function - basis
of the indicated deviation
(Parameter for Multi-function)
You can set how deviation values
should be indicated for the fixed
weighing function.
(Refer to Section 6-2.1.)
#168 Sample setting - Rank range
(Parameter for Multi-function)
You can set the calculation rule of
the sample weight measurement in
determining the weight ranking for
the rank combination function.
(Refer to Section 6-4.)
#178 Support function
(Parameter for Sub-display)
You can set the Just weight
function (for showing
insufficient/excessive weight of
items) or the Just quantity function
(for showing insufficient/excessive
quantity of items).
Item
1–20: Valid tare must have a weight of at least 1 to 20 scale
0–255: The value of the unit set in #163 (Factory default: 10.)
Option Function (Underlined options are factory defaults.)
0: Valid tare must have a weight of at least 4 scale intervals.
intervals. (Factory default: 4)
0: Scale intervals
1: Ratio with respect to the target value
2: Ratio with respect to the weighing capacity
0: Disable automatic set time (the lower limit is set by
placing a load)
1: After 1 second
2: After 2 seconds
3: After 3 seconds
4: After 4 seconds
5: After 5 seconds
0: Lower limit basis
1: Allowable weight range basis
0: Small (1  )
1: Small (1.5  )
Normal (2  )
2:
Large (2.5  )
3:
Large (3  )
4:
0: Disabled
(Always show the lowest limit on the Sub-display during
the Checkweighing function.)
1: Just weight function
(Show the insufficient/excessive weight on the Sub-
display during the weight measurement for the
Checkweighing function.)
2: Just quantity function
(Show the insufficient/excessive quantity on the Sub-
display during the weight measurement for the
Checkweighing function and the Counting function.)
17