Table of Contents
Advertisement
Fixed weighing function - How to register/edit the limits through regular setup
[Example] To select the program number 3, and set the allowable weight range to values between 100 g and
120 g
Before registering program data, set the user parameter #01 to 1 on the
user parameter setting screen. * For how to set a user parameter, refer
to [Section 4-3].
Turn on the power, and then press
"PAC" appears, indicating the setting of the Fixed weighing function,
and the last two digits are a program number.
* When the Main-display shows the program number, pressing
returns to the previous weighing screen.
* If the indicated program contains registered data, the blue lamp
comes on.
[Entering the program number.]
With the numeric keypad, enter '3' as the program number, and then
press and hold down
[Entering the target value.]
With the numeric keypad, enter '1' '0' '0' as the target weight, and then
press
.
* Pressing
selection screen.
[Entering the tolerance.]
With the numeric keypad, enter '2' '0' as allowable weight, and then
press
.
PLU
* Pressing
screen.
[Entering the preset tare.]
* If there is no need to enter this setting, leave this as zero and press
.
PLU
With the numeric keypad, enter '2' '0' as the preset tare, and then press
.
PLU
* Pressing
the upper limit.
The data has been registered in the program number 3. You can call the
registered data even if the power is turned off.
Now, you can proceed with the work using the fixed weighing function.
Fixed weighing function - How to weigh items
[Example] To proceed with work by setting allowable weight range to values between 100 g and 120 g
Press
to call the program number selection screen. With the
numeric keypad, enter '3' as the program number, and then press
Now that the registered program is called, you can start work.
* You cannot call the settings of an unregistered program number through
this procedure.
Alternative calling method (Easy program call)
When the Main-display shows 0, enter '3' with the numeric keypad.
Then press
program data in this way.
Operation
.
.
on the right screen returns to the program number
on the right screen returns to the target value entry
on the right screen returns to the screen for entering
Operation
when the indication is blinking. You can also call
Chapter 6
30
How to use the Multi-functions
Display
Display
.
Advertisement
Table of Contents
