Table of Contents
Advertisement
Chapter 6
How to use the Multi-functions
Just quantity function - How to set it 2 (To register the unit weight)
[Example] To select the program number 2, set the allowable weight range to values between 300 g and 315 g,
and set the unit weight using 10 samples
Referring to - in the section "Checkweighing function - How to
register/edit the limits through regular setup," make the settings up to the
upper limit. Then open the unit weight setting screen.
[Weighing samples to determine the unit weight.]
First, enter the number of samples to be placed for weight measurement.
With the numeric keypad, enter '1' '0' as the sample size, and then press
.
* Pressing
upper limit.
Place the number of samples entered in Step (in this example: 10
samples) on the platform of the instrument, and then press
* Zero point reset and One-touch tare can be used during sample weight
measurement.
* The Automatic tare function is also enabled during sample weight
measurement. If the Automatic tare function is set to ON, place a container
first.
* Long-pressing
sample and returns to the sample size entry screen.
* When you are editing the program data already registered, press
without anything put on the instrument. Then the system keeps the
previous setting of sample weight measurement and proceeds to the next
step.
[Entering a preset tare.]
* If there is no need to enter this setting, leave this as zero and press
With the numeric keypad, enter '2' '0' as the preset tare, and then press
.
* Pressing
The data has been registered. You can call the registered data even if the
power is turned off.
Now, you can proceed with the work using the Checkweighing function (Just
quantity function).
Just quantity function - How to weigh items
[Example] To proceed with work when the allowable weight range is set to values between 300 g and 315 g
The program-calling method, weight indications (Main-display), and lamp
lighting rule are basically the same as those of the Checkweighing
function (refer to page 24). When no items are placed on the instrument,
the Sub-display shows the lower limit.
Place items on the instrument.
When the measured weight is lower than the lower limit (300 g), the Sub-
display shows the shortage in quantity as a minus value.
When the measured weight is higher than the upper limit (315 g), the Sub-
display shows the excess in quantity as a plus value.
When the measured weight falls within the Allowable weight range, the
blue lamp comes on, indicating that it is an allowable weight.
Operation
on the right screen returns to the screen for entering the
discards the weight measurement of the current
on the right screen returns to the sample weighing screen.
Operation
.
27
Display
.
Display
Upon underweight
Upon overweight
Upon allowable
weight
(Blue lamp comes on)
Advertisement
Table of Contents
