Omron S82K Manual page 4

S82K
Specifications Table
– continued from previous page
Item
Output Voltage adjust-
(see ment range
note 2)
Output
Ripple
(see (see (see note 1)
note 2) 2)
Input variation
influence
Load variation
influence
Temperature varia-
tion influence
(see note 1)
Rise time
Hold time
(see note 1)
Note: 1. Defined with a 100% load and the rated input voltage (100 or 200 VAC).
2. The output specification is defined at the power supply output terminals.
3. The settings for the output voltage must be within the following range:
+V: 1% of the rated value
–V: 5% of the rated value
4. When using the 7.5-W single-output models within the input voltage range between 90 and 110 VDC, the protection function will
operate at a current of 95% to 160% of the rated load current.
5. When the ambient temperature exceeds 25 C, the overload protection function will operate at a current of 92% to 111% of the
rated load current.
6. Circuit-breaker type. To reset, turn the input power supply OFF, then after 1 min has elapsed, turn the input power supply ON
again.
4
Non–PFC models
Single output Dual Single output
outputs
3 W 7.5 W 7.5 W 15 W
10% (V.ADJ) Not 10% (V.ADJ); –10% to 15% for S82K-03012/-03024/-05024
pos-
sible
(see
note 3)
2% (p-p) max.
0.5 % max. (at 85 to 264 VAC input, 100% load)
1.5% max. +V: 1.5% max.
(0 to 100% load) 1.5% (0 to 100% load)
max.
-V: 3 %
max.
(0 to
100%
load)
0.05%/ C max.
100 ms max. (up to 90% of output voltage at rated input
and output)
20 ms min.
(This table continues on the next page.)
30 W 50 W 90 W
0.5 % max. (at 85
to 132 VAC/170
to 264 VAC input,
100% load)
200 ms max.
S82K
PFC model
100 W 240 W 240 W
0.5 % 0.5 % max.
max. (at 85 to
(at 85 253 VAC in-
to 132 put, 100 %
VAC/ load)
170 to
253
VAC in-
put,
100%
load)
1.5% max.
(10 to 100% load)
300 ms 1,000 ms
max. max.