Related Test Procedures - Safeline SL6 Manual

Related test
Procedures
* Telephone line check
1.
Power up the unit.
2. Lift the configuration handset.
3. Wait for dial tone.
4. Dial "0".
5. Wait for new dial tone.
6.
Call another telephone and start a normal conversation.
7. Hang up the configuration handset to end the call.
If one of these steps is not successful the problem may not be with
the unit, but due to incorrect wiring or faulty/missing telephone
line.
** Noise check
1. Power up the unit.
2. Lift the configuration handset.
3.
Wait for dial tone.
4.
Dial "0".
5. Wait for new dial tone.
6. Press a number on the keyboard.
7. The dial tone stops and you hear silence.
8.
When you hear noise or humming, the problem may be due to
induction in the phone cable.
9. Hang up the configuration handset to end the call.
According to the phone companies' regulations, the phone line
must be installed on a separate cable.
Redirect the cable by changing its position or finding another
pair that is free of distortion, or use shielded pair when available.
When none of these solutions apply, install a separate cable for the
telephone line.
*** Microphone check
Call in to the SL6+ and press the following numbers on the caller's
phone.
1. Press "7" to activate the car's microphone.
2. Press "*" activates microphone of the caller.
3. Press "4" for automatic switching of microphones.
If you can speak through the microphones the hardware is OK.
45 SafeLine SL6+ v.3.9.0 EN