Hisselektronik Introduction www.safeline.se The content in this catalogue is protected by the copyright laws. The name SafeLine™ is a registered trademark. All content in this catalogue is owned by Hisselektronik AB.
Page 4
Hisselektronik Introduction www.safeline.se 1. Cable for connections. 2. Rs232 PC connection. 3. Volume settings. 4. Relay output connection. 5. Jumper for NO/NC button. NO = without jumper. NC = with jumper. 6. Jumper for lift/entry phone.
Hisselektronik Assembly instructions www.safeline.se Assembly instructions Complete telephone assembly in the elevator car requires a space of only 70X130mm for installation. The alarm signal button can be changed between normally-open/ normally-closed. It is possible to use the existing alarm button.
Page 6
Hisselektronik Hints www.safeline.se To disconnect a vocal connection the receiving party should press “9” or “#” otherwise the line will be busy up to 90 seconds after the call is completed. To call the lift telephone just call the connecting telephone number, the telephone will automatically answer after two signals.
To program the telephone, a programming unit HT99-H is needed. It is also possible to program the telephone by using a dial tone telephone, or with our Window-based PC software Safeline Pro (can be down loaded at no cost from our web-site www.safeline.se).
Page 8
TEL. NUMBER. the supervision alarm Breakdown alarm card #=NEXT D=HELP (only for Safeline 2000) mounted in the unit * Step 12: Write the telephone Press ”#” to go to The battery alarm sends the...
Explanation: Next to do: Tip: step… shows: Turn on the Handunit for After about 3 seconds Safeline 1000/2000 the next text will show. power ----------------- Version 1.15 Step 2: Write the 8-digits P100/ Press ”#” to go ALARM CODE 1 =...
Page 10
Step by The display Explanation: Next to do: Tip: step… shows: Turn on the Handunit for Press ”D” within 3 Safeline 1000/2000 seconds. power ----------------- Version 1.15 Initialising The internal memory is This will set to zero. automatically display will...
Hisselektronik Dial tone programming www.safeline.se Programming from a dial tone telephone: It is possible to program the telephone by calling to it. By using different dial tone commands it is possible to program all codes and telephone numbers to the telephone.
Page 12
*82* 0 (standard) - 9 Dial tone detect *83* 0=Off 1=On (standard) Set to 0 if SafeLine is having problems detecting the dial tone. Receipt to SLCC *84* 0 = Off (don’t send receipt), 1 = On (send receipt) Break on new alarm...
Hisselektronik Common settings www.safeline.se Example on common alarm telephone settings To register a P100/CPC code 11335588 Primary number to custodian (voice call) 046-443322 Secondary number to alarm-receiving operator 031-223344 If only one telephone is connected to the line: Call the alarm telephone. It will answer after 3 distinctive tones after 2 ring signals (can be changed to 0-16 signals).
Hisselektronik Volume control www.safeline.se Programming with SafeLine Pro You can also program SafeLine™ 1000 with our free PC- software. The program is free and can be downloaded from our web site www.safeline.se/. Volume control...