Safeline TTR Installation Manual

Emergency telephone for lifts
Hide thumbs Also See for TTR:

Advertisement

Quick Links

SafeLine
Installation manual
Emergency telephone for lifts. Complies to EN81-28 and
EN81-70 standards.
ENGLISH v.1.01
05.2012
PATENT PENDING
TTR

Advertisement

Table of Contents
loading

Summary of Contents for Safeline TTR

  • Page 1 SafeLine Installation manual Emergency telephone for lifts. Complies to EN81-28 and EN81-70 standards. ENGLISH v.1.01 05.2012 PATENT PENDING...
  • Page 2 Technical daTa Power: Supply voltage: 230 VAC. Min: 3.9W , Max: 6.9W Battery: Battery voltage: 12V. Lead battery. Capacity: 0.8 Ah. Charge: 13.7-13.9 V, max. 200 mA. Emergency light output: 12V max 0.5A. emergency light: Acoustic emergency signal output: 12 VDC max 0.5A. inputs: 10-30 Volts;...
  • Page 3: Table Of Contents

    Table of contents Introduction General information Congratulations on your new “TTR” elevator alarm Safety Precautions! Installation Component list Wiring diagram -Emg. light and pictograms Mounting Wiring diagram -Extra station card Wiring diagram -Emg. bell and -light Wiring diagram -PSTN LINE (Max 9 units) Wiring diagram -Emg.
  • Page 4: General Information

    The SafeLine may only be used for its intended purpose. Note in particular that, no unauthorized changes or additions may be made inside the SafeLine or to individual components.
  • Page 5: Congratulations On Your New "Ttr" Elevator Alarm

    TTr and other alarms! General: • Telephone in machineroom must be connected to the RJ12 jack on the front of the TTR unit. • RJ12 jack next to the 14 pin connector is for the microphone, alternatively microphone and external speaker (sold separately).
  • Page 6: Installation

    When the station’s alarm button is pressed for the set delay time, an emergency call is emitted. The recorded message can be different for each unit. ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 7 5. Terminals For the extra remotes. 6. extra remote (max 2) Mounted in the lift shaft, on top, or under the car. 7. GSm antenna ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 8: Mounting

    To avoid GSM interference: Place the main unit, the stations and the GSM antenna more than 1.5 meters apart. >>1,5 m >>1,5 m >>1,5 m mounting interface boards 44553 44553 1000 1000 44553 44553 1000 1000 PSTn ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 9: Wiring Diagram -Emg. Bell And -Light

    EMG. LIGHT - Jumper settings With the jumpers “J8” and J9 in the position as shown left, the SafeLine TTR can supply backup power for emergency light in the lift car. The jumpers “J1”, “J2” and “J5” shall be set as shown left and shall not be changed.
  • Page 10: Wiring Diagram -Emg. Bell And Pictograms

    GREEN PICT. Jumper settings With the jumpers “J8” and J9 in the position as shown left, the SafeLine TTR can operate pictograms according to EN 81-28 / EN 81-70. The jumpers “J1”, “J2” and “J5” shall be set as shown left and shall not be changed.
  • Page 11: Wiring Diagram -Emg. Light And Pictograms

    EMG. LIGHT – Jumper settings With the jumpers “J8” and J9 in the position as shown left, the SafeLine TTR can sypply backup power for emergency light in the lift car. The SafeLine TTR can also operate pictograms according to EN 81-28 / EN 81-70.
  • Page 12: Wiring Diagram -Extra Station Card

    WirinG diaGram -PSTn line (maX 9 uniTS) Connect the telephone line in parallel according to the picture above. It’s possible to connect up to 9 SafeLine TTR units to the same telephone line. ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 13: Activating The Sim Card

    3G will not function. The SafeLine TTR can only recognize the PIN code if the code is set to “1234”, “0000”, “1111”. In some cases the code can also be deactivated. If the PIN code is set to “1234”, “0000” or if it is deactivated the SIM card can be moved from the SafeLine TTR to any of SafeLine GSM products.
  • Page 14: Start Up

    4 sec Show GSM signal strength. Press 3 times Start a battery condition test Press once Resets an active alarm. Aborts calls in progress. ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 15: Led Indication Pictograms

    LED is turned off when the call is terminated. Strictly en81-70 (*88*1#) Green led yellow led Green steady: yellow steady: Call connected. Activated alarm. Remains lit until reset. ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 16: Test Procedure After Installation

    SafeLine Lift the handset Internal dial tone No tone Press Check the handset Phone line dial tone No tone Dial out Go to Troubleshoot ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 17: Configuration Methods

    Dial the phone number of the SafeLine. Enter the function codes on the phone keypad to start confi guration (password has to be entered). ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 18: Remote Config. With Telephone First Step

    WiTh TelePhone firST STeP • In order to remotely confi gure the SafeLine, the unit must fi rst be put into confi guration mode via voice communication mode. To enter voice communication mode, refer to the instructions below.
  • Page 19: Remote Config. With Telephone Second Step

    Call disconnected or end of 2 short beeps? confi guration. Invalid input (one long tone) SafeLine will restart with new Last code has to be reentered settings ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 20: On-Site Configuration With Telephone

    Call disconnected or end of 2 short beeps? confi guration. Invalid input (one long tone) SafeLine will restart with the Last code has to be new settings reentered ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 21: Configuration Example

    GSM modem if using Caller ID) End programming If at any time you need to start over, use the factory reset command *99*1# ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 22: Configuration Codes Table

    Alarm character LMS *45* - - # LMS(Lift Monitoring System) (Battery alarm) Normally 17 Alarm character Test alarm *46* - - # Normally 26 ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 23 Select which message(s) to send to the alarm receiver at an alarm call. 0 = None (Default) 1 = Start of alarm 2 = Start+end of alarm ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 24 It is possible to enter manual voice switching mode although the unit is programmed as automatic by pressing ”*”. No ascending tones will be heard. ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 25: Operating

    Press the button on the station for less than one second (if you press longer an alarm call will be made). The SafeLine TTR will ring for 5 seconds. ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 26: Intercom -Machine Room To Car/Pit/Top Of Car

    Press 1 to call the lift car. Press 2 to call the car-top. Press 3 to call the lift pit. Press 00 to enter programming mode. ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 27: Emergency Calling Process

    Answer? Calling 2nd phone number Answer? Calling 3rd phone number Answer? Calling 4th phone number Answer? Alarm operator Emergency call made connection fi nished ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 28: Service

    Testing the battery alarm: • Unplug the battery contact during the battery status check. • The SafeLine TTR will now emit a battery alarm and LED 2 and the battery alarm relay will be activated (if so configured). cancelling the battery test: • Switch the main voltage supply (230 V) off and back on to cancel the test.
  • Page 29: Troubleshooting

    At least one phone number (and one ID code if using data identification) must be programmed to enable making a call from the unit. Refer to the parameter list (*11*). ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 30: Service Repair Form

    SerVice rePair form return procedure Safeline accepts only returns which are accompanied by a completed Service form or a simular serviceform from buyer. If the product has been purchased from one of our distributors the buyer must fi rst contact the distributor concerned in each country for assistance.
  • Page 31 Service ENGLISH v.1.01 © 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
  • Page 32 BELGIUM Tel: +46(0)84477932 Tel: +32(0)2 762 98 10 Fax: +46(0)84477931 Fax: +32(0)2 762 97 10 E-mail: order@safeline.eu E-mail: order@safeline.eu SafeLine-Deutschland SafeLine Elevator Parts UK Westfalenstraße 22a 3 Evegate Park Barn D-51688 Wipperfürth Smeeth DEUTSCHLAND Ashford Kent Tel: +49 (0) 2267 - 8 67 96 63 TN25 6SX E-mail: order@safeline.eu...

Table of Contents