Software Version; Showroom Programme; Factory Default - Miele DG 7440 Operating And Installation Instructions

Settings
Running RemoteUpdate
Information about the content and
scope of an update will be provided in
the Miele@mobile app.
A message will appear in your steam
oven display if a software update is
available.
You can install the update immediately
or postpone this until later. When the
steam oven is switched on again, you
will be reminded about the update.
Deactivate RemoteUpdate if you do not
want to install the update.
The update may take several minutes.
Please note the following information
about the RemoteUpdate function:
– You will only receive a message when
an update is available.
– Once an update has been installed, it
cannot be undone.
– Do not switch the steam oven off
during the update. Otherwise, the
update will be aborted and will not be
installed.
– Some software updates can only be
carried out by your Miele Dealer.

Software version

The software version is intended for
your Miele dealer. You do not need this
information for domestic use.
40

Showroom programme

This function enables the steam oven to
be demonstrated in showrooms without
heating up. This setting is not needed
for domestic use.
Demo mode
If you have demo mode activated,
Demo mode switched on. The appliance
will not heat up will appear when you
switch the steam oven on.
– On
Touch the OK sensor control for at
least 4 seconds to activate demo
mode.
– Off
Touch the OK sensor control for at
least 4 seconds to deactivate demo
mode. You can then use the steam
oven as normal.

Factory default

– Appliance settings
Any settings that have been altered
will be reset to the factory default
settings.
– User programmes
All User programmes will be deleted.
– Recommended temps.
Any recommended temperatures that
have been changed will be reset to
the factory default settings.