Miele DG 155 Installation Instructions Manual
Miele dg155: install guide
Hide thumbs
Also See for DG 155:
- Operating instructions manual (56 pages) ,
- Installation instructions manual (12 pages) ,
- Installation instructions manual (12 pages)
Related Manuals for Miele DG 155
Summary of Contents for Miele DG 155
-
Page 1: Installation Instructions
Installation instructions Steam oven DG 155 DG 155-1 DG 155-2 DG 155-3 To prevent accidents and machine damage, read these instructions before installation or use. M.-Nr. 05 229 051... -
Page 2: Table Of Contents
Installation above a Miele oven ........ -
Page 3: Important Safety Instructions
However, under certain conditions it may be possible for an installation in these applications. Please contact the nearest Miele dealer or the Miele Technical Service Department with specific requirements. This steam oven is designed for installation in cabinetry or beneath a counter top. - Page 4 IMPORTANT SAFETY INSTRUCTIONS Disposal of an old appliance Before discarding an old appliance, disconnect it from the electricity supply, cut off the power cord and remove any doors to prevent hazards. Note to the installer: Please leave these instructions with the consumer of the appliance.
-
Page 5: Appliance And Cut Out Dimensions
Installation in tall cabinetry ( 3 3 0 ( 2 2 ( 5 9 a Steam oven b Cabinet opening c Terminal block d Outlet or junction box. This should be accessible after the appliance has been installed. e Power supply cord... -
Page 6: Installation Under A Counter Top
Installation under a counter top ( 3 3 0 ( 5 4 7 ( 2 2 ( 5 9 a Steam oven b Cabinet opening c Terminal block d Outlet or junction box. This should be accessible after the appliance has been installed. -
Page 7: Installation Above A Miele Oven
Power supply cord g Oven Note: The steam oven must not rest directly on top of the oven. The steam oven should be supported by a shelf or ledges. Appliance and cut out dimensions ( 5 4 7 m n . -
Page 8: Installing The Oven
Installing the oven Securing the oven After aligning the oven it must be secured in position. Open the oven door and using the supplied screws g, secure it to the cabinet through the holes on either side of the vertical oven trim. -
Page 9: Electrical Connection
Make sure your electrical supply matches the data plate. WARNING : THIS APPLIANCE MUST BE GROUNDED Installing the oven For USA only The appliance is provided with 3 terminal leads: 1 black wire (L1), 1 red wire (L 2) and 1 green wire (GND) that must be connected to a dedicated junction box. - Page 12 Alteration rights reserved / 1204 M.-Nr. 05 229 051 / 00 This paper has been bleached without the use of chlorine.