Fig. 47: Installing The Wall Insert 2; Table 50: Tightening Torque (72002) - ABB Power2 850-M Operation Manual

Operation Manual / Power2 850-M / Low-pressure stage
9 Disassembly and assembly / 9.14 Installing the wall insert
Fig. 47: Installing the wall insert 2
Part number Tightening torque
72002 M16x104
50 Nm
Table 50: Tightening torque (72002)
1. Remove plate (90032), screw (90656), nut (90432) and plates (90031).
2. Remove the bracket (90030).
3. Detach speed measurement cable from provisional holder and insert cable con-
nector (86515).
4. Fit four studs (72002) in the upper area. Observe tightening torque.
© Copyright 2022 ABB. All rights reserved. HZTL4062_EN Rev.E March 2022