Installing The Air Suction Branch; Fig. 49: Installing The Air Suction Branch; Table 52: Tightening Torque (72004) - ABB Power2 850-M Operation Manual

Operation Manual / Power2 850-M / Low-pressure stage
9 Disassembly and assembly / 9.16 Installing the air suction branch
9.16

Installing the air suction branch

Fig. 49: Installing the air suction branch
Part number
72004
Table 52: Tightening torque (72004)
1. Remove the two opposing nuts (72004) and washers (72003) that were used to secure
the wall insert.
2. Loop around air suction branch (82000) with lifting gear.
3. Position the air suction branch.
4. Fit nuts (72004) with washers (72003) and tighten nuts (72004).
Reinstall dismantled insulation.
u
Reinstall all air lines according to the instructions of the enginebuilder.
u
© Copyright 2022 ABB. All rights reserved.
Thread and tightening torque
HZTL4062_EN
M16
200 Nm
Rev.E March 2022