Operation Manual / Power2 850-M / Low-pressure stage
10 Taking out of operation at short notice / 10.1 Possible emergency re-
pairs
10.1.1
Manufacturing the cover plate
The cover plate and the other parts that are required are not part of the scope of delivery of
Turbo Systems and must be manufactured by the operator on the basis of the drawing
Fig. 52: Cover plate / gasket, sleeves and screws
Parts required
¡
1 cover plate (01) (recommended material: 1.4541 / 1.4571)
¡
1 gasket (02) (temperature resistant up to 550 °C)
¡
8 additional screws (03) to the screws (42087) from the scope of delivery
¡
15 sleeves (04)
Fig. 52: Cover plate / gasket, sleeves and screws
Cover plate (gasket), sleeves and screws, dimensions [mm]
Ø1
Ø2
655
600
Table 55: Cover plate / gasket
© Copyright 2022 ABB. All rights reserved.
Ø3
Ø4
Ø5
14
14
20
HZTL4062_EN
→98).
B1
B2
10
32
(see
L1
M1
60
M12
Rev.E
March 2022