Installing The Low-Pressure Stage; Fig. 12: Suspension Of Complete Low-Pressure Stage - ABB Power2 850-M Operation Manual

Operation Manual / Power2 850-M / Low-pressure stage
3 Removal and installation / 3.3 Installing the low-pressure stage
3.3

Installing the low-pressure stage

Fig. 12: Suspension of complete low-pressure stage
Attach one lifting gear to each of the two bearing casing suspension points.
u
Check that the orifices specified for the low-pressure stage have been installed in both oil
u
supply lines.
Check that the gaskets have been correctly fitted at the oil inlet and the oil outlet in the
u
bracket.
Align the low-pressure stage on the engine.
u
Tighten the fixing elements on the foot according to the instructions of the engineb-
u
uilder.
Attach all gas, air, water and oil pipes in accordance with the instructions of the engineb-
u
uilder.
Connect the cable connector to the speed sensor.
u
Fit insulation according to the instructions of the enginebuilder.
u
© Copyright 2022 ABB. All rights reserved. HZTL4062_EN Rev.E March 2022