Axial Clearance A After Assembly; Fig. 48: Measuring Axial Clearance A; Table 51: Axial Clearance A - ABB Power2 850-M Operation Manual

Operation Manual / Power2 850-M / Low-pressure stage
9 Disassembly and assembly / 9.15 Axial clearance A after assembly
9.15

Axial clearance A after assembly

CAUTION
Clearances outside the tolerance
Serious damage to engines or property can be caused by clearances outside
the tolerance and excessively worn parts.
Have the components assessed and, if necessary, replaced by a Turbo
u
Systems service station.
Fig. 48: Measuring axial clearance A
The axial clearance (A) must be measured prior to removal and after installation of the cart-
ridge group.
Measure and note axial clearance (A).
u
Table 51: Axial clearance A
© Copyright 2022 ABB. All rights reserved.
Axial clearance A [mm]
0.32 ... 0.53
HZTL4062_EN Rev.E March 2022