Installing The Filter Silencer; Fig. 50: Installing The Filter Silencer; Table 53: Tightening Torque (72004 / 77022) - ABB Power2 850-M Operation Manual

Operation Manual / Power2 850-M / Low-pressure stage
9 Disassembly and assembly / 9.17 Installing the filter silencer
9.17

Installing the filter silencer

Fig. 50: Installing the filter silencer
Part number
72004
72004 (nuts that are difficult to access)
77022
Table 53: Tightening torque (72004 / 77022)
1) Application with adapter 90249 and special key 90250/90251, see below
1. Fit sleeves (77023) and nuts (77022) in accordance with position of filter silencer and
tighten nuts (77022).
2. Remove the two opposing nuts (72004) and washers (72003) that were used to secure
the wall insert.
3. Fit the swivel lifting eye (90231) to the filter silencer (81000). Attach the lifting gear to
the swivel lifting eye (90231) and loop through the eyelets at the rear of the filter silen-
cer (81000).
4. Fit the filter silencer.
5. Fit nuts (72004) and washers (72003) and tighten nuts (72004).
If present: Fit supply line for compressor cleaning to filter silencer.
u
Reinstall dismantled insulation.
u
© Copyright 2022 ABB. All rights reserved.
Thread and tightening torque
Pre-tightening torque 60 Nm
Tightening angle 60° ±5°
HZTL4062_EN
M16
200 Nm
1)
150 Nm
M16
200 Nm
Rev.E March 2022