Extron electronics IP Link Pro xi IPL EXP PDU4H User Manual page 43

Command Function
Resets
Reset unit settings
Absolute system reset (retain IP)
Absolute system reset
IP settings and connection reset
Reboot commands
Reboot the system
24
Restart the network connection
NOTES:
• Firmware upgrades require the
• Changes made to the IP address, subnet mask, DHCP, or gateway address do not take effect until the
is issued, except for changes made via the
a reboot.
Ethernet (network) access commands
Enable network access
24
Disable network access
24
View network access setting
Host name operations command (for finding the IP address of a host name)
Get the IP address by host name
NOTES:
• If DNS servers cannot resolve the host name, the command returns the IP address as
• If DNS servers cannot be reached within approximately 3 seconds, the response is E18 (command timed out).
• The named device does not need to be online or contactable in order to find and report the resolved IP address.
X8#
= Enabled/disabled status
KEY:
SIS Command
(Host to Unit)
E }
ZXXX
E }
ZY
E }
ZQQQ
E }
1ZQQQ
E }
1BOOT
E }
24 2BOOT
E }
1BOOT command to complete.
CISG
commands (see page 32), which take place immediately and do not require
E }
E 1 * 1 ETHN
E }
E 1 * 0 ETHN
E }
E 1 ETHN
E name }
V 1 * < > HNAM
Verbose mode 2/3:
0 1
= disabled, = enabled
IPL EXP PDU4H • Modes of Operation, SIS Control and Configuration
Response Additional description
(Unit to Host)
Zpx ]
Reset all settings (except IP settings)
to factory default settings. Excludes IP
settings such as IP address, subnet
mask, unit name, gateway address, and
passwords, and does not remove file
system settings.
Zpy ]
Same as
settings such as IP address, subnet
mask, gateway IP address, unit name,
DHCP setting ,and port mapping (Telnet,
Web, direct access) in order to preserve
communication with the device. This
command also erases the user file
system and passwords
Zpq ] Master reset. This resets ALL device
settings (including IP address settings)
to default. Does not affect the installed
firmware version.
Zpq1 ]
Resets only IP settings and restarts
the network connection. The
response is followed by
Boot2 ]
Boot 1 ]
Boot 2 ]
EthnE ]
1 * 1 Network access is enabled by default.
EthnE ]
1 * 0
X8#]
<IP address> ]
name <IP address> ]
HnamV 1 * < > *
0.0.0.0
.
E ZQQQ
except excludes IP
Zpq1 ]
Reconfig ]
and
responses.
E }
2BOOT command
35