Extron electronics IP Link Pro xi IPL EXP PDU4H User Manual page 4

FCC Class B Notice
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to the
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. There is no
guarantee that interference will not occur. If this equipment does cause interference to radio
or television reception, which can be determined by turning the equipment off and on, you
are encouraged to try to correct the interference by one or more of the following measures:
•
•
•
•
In order to maintain compliance with FCC regulations, shielded cables must be used with
this equipment. Operation with non‑approved equipment or unshielded cables is likely to
result in interference to radio and TV reception. The user is cautioned that changes and
modifications made to the equipment without the approval of the manufacturer could void
the user's authority to operate this equipment.
NOTE: For more information on safety guidelines, regulatory compliances,
Battery Notice
This product contains a battery. Do not open the unit to replace the battery. If the
battery needs replacing, return the entire unit to Extron (for the correct address, see the
Extron Warranty section on the last page of this guide).
CAUTION: Risk of explosion if battery is replaced with an incorrect type. Dispose of
ATTENTION : Risque d'explosion si la batterie est remplacée par un type incorrect.
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
EMI/EMF compatibility, accessibility, and related topics, see the
Regulatory Compliance Guide
used batteries according to the instructions.
Mettre au rebus les batteries usagées selon les instructions
on the Extron website.
Extron Safety and