Advertisement
III. PROCESSING TRAY
A.
Removing the Processing
Tray
1) Remove the inside right cover and the rear
cover. (Figure 3-103)
2) Remove the stapler cover. (Figure 3-619)
3) Remove the stapler. (Figure 3-619)
4) Remove the mounting screw [1], and
remove the inlet sensor [2].
5) Remove the E-ring [4] from the rear of the
linking shaft [3]; then, shift the gear [5]
and the bushing toward the front.
Caution:
When sliding the gear, take care not to drop
the parallel pin from the shaft.
COPYRIGHT © 1999 CANON INC.
CANON FINISHER-E1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
[2]
[1]
Figure 3-301
[5]
[6]
Figure 3-302
3-7
Advertisement
Chapters
