Advertisement
CHAPTER 3 MECHANICAL SYSTEM
6) Detach the belt [8] from the pulley [7] at
the front of the linking shaft [3], and pull
out the linking shaft [3].
7) Disconnect the two connectors (J6 and J9)
[10] from the finisher controller PCB [9],
and remove the two mounting screws [11]
from the inside of the body and the two
mounting screws [12] from the body
frame*; then, detach the processing tray
unit [14] by moving it toward the copier.
*At this time, the grounding plates [13]
will also come off.
3-8
COPYRIGHT © 1999 CANON INC.
[8]
[7]
Figure 3-303
[11]
[14]
Figure 3-304
[14]
[13]
Figure 3-305
CANON FINISHER-E1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[3]
[11]
[10]
[10]
[9]
[12]
Advertisement
Chapters
