Base Assembly - Spacerails LEVEL 4 Quick Start Manual

C
SEE-SAW ASSEMBLY
Step 1: Cut 2 rails to 55mm. Insert 1 rail into
each hole on the See-Saw.
See-Saw Arm
Step 3: Insert See-Saw into Arm Holder B.
D

BASE ASSEMBLY

Step 1: Interlock Base block tabs
as shown below.
Step 2: Press Base Holder A and
Base Holder B pieces into the Base
blocks for a more secure hold.
Page 4
55mm rail pieces
2
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
Step 2: Insert the See-Saw Arm and the rails into
the Rail Clip. You may need to adjust the See-Saw
after installing it as it may have shifted.
Rail Clip
Step 4: Insert the See-Saw into the Rail Stand
(300mm Shaft). See shaft assembly on page 8
for exact placement.
1
2
NOTE:
Base Holder B is used
here instead of A.