X.cross Brace; Strut Tube Assembly; Folding The Chair; Aa.growing Seat Pan (Optional) - Sunrise Medical Zippie TS Owner's Manual

E N G L I S H
X. CROSS BRACE
1. Adjustment
a) Remove the four bolts (A) that attach the cross brace to the side frames.
b) Move the cross brace to the desired location on the tabs (B).
c) Replace and tighten the bolts.
NOTE– Align the bolts through holes in the tabs that correspond on each side. Re-tighten bolts to 100 in.-lbs.
Cross braces have 2" of width growth.
Y. STRUT TUBE ASSEMBLY
NOTE– Strut Tubes are installed on rigid chairs.
1. Width Adjustment
a) Remove the saddle bolts (A) from each end of the strut tubes (B) for all strut tubes.
b) Remove hardware (C) from strut tube.
c) Slide the adjustable extension (D) to the desired width.
d) Replace and tighten the saddle bolts in the strut tubes.
NOTE–
Strut tubes have 2" width adjustment available. Size changes may require a larger seat insert and
footplates. Call your authorized Sunrise supplier for details. Use a torque setting of 100 in.-lbs.
when making this adjustment.
Z. FOLDING THE CHAIR
NOTE–
Only chairs with cross brace assembly will fold.
1. Folding/Opening
a) To fold the chair, remove the seat and back.
b) Pull the cross brace strap (A) up.
c) Press the side frames together firmly.
d) To open the chair, extend fingers and apply even pressure with palm of hand directly
on cross brace until it is fully extended.
e) Replace the seat and back.
f) To avoid pinching, be careful when folding or unfolding a chair.
AA. GROWING SEAT PAN
1. Removing and Attaching the Seat Pan (Fig. 36)
a) To remove, grasp front of seat pan where indicated in Figure 36 and firmly pull upward
until seat mounting clips disengage from the frame.
b) To reattach, position seat pan on frame rail as desired and push down firmly on seat
pan where it is attached to the seat mounting clips. Be sure to engage all four clips on
frame rails.
NOTE–
Rear of seat pan will be labeled.
Check for engagement by pulling up lightly on seat pan. It should not move
upward. Failure to check for engagement may lead to injury if the seat mount-
ing clips are not fully seated.
2. Adjusting Seat Pan Width (Fig. 37)
a) Remove the two screws that secure each seat mounting clip to the seat pan.
b) Position the seat mounting clips to the desired position, reattach the screws. Each hole
is .5" apart for a total of 2" of width adjustment range.
NOTE–
Tighten screws to 100 in.lbs. torque.
c) Repeat steps 1 and 2 for each mounting clip.
NOTE–
Both sides must be mounted to same hole position.
3. Adjusting Seat Pan Depth (Fig. 37)
a) Loosen the two lock nuts on under side of seat pan that attaches front seat pan panel
to rear seat pan panel.
b) Reposition seat pan to the desired length, and reattach the lock nuts.
NOTE–
Tighten lock nuts to 100 in. lbs. torque.
(Fig. 32)
(Fig. 33, 34)
(Fig. 35)
(optional) (Fig. 36, 37)
WARNING
19
A
B
A
B
C
A
Rear Panel
Front Panel
Front
Depth adjustment
Front
Lock
nut
Width
adjustment
Seat mounting clips
I X .
32
33
34
D
35
36
37
XXXXXXX Rev. A