Main Frame; Backrest; C.swing-Away Hangers (60º, 70º, Or 90º); D.articulating Legrest (Optional) - Sunrise Medical Zippie TS Owner's Manual

E N G L I S H
NOTE–
Setting the wheelchair on a flat surface helps make these procedures easier.
NOTE ON TORQUE SETTINGS– A torque setting is the optimum tightening which should be made on a
particular fastener. A torque wrench which measures in.-lbs. should be used when tightening fas-
teners on Sunrise wheelchairs. Unless otherwise noted, use a torque setting of 60 in.-lbs. when set-
ting up this wheelchair.
A. MAIN FRAME
Set the main frame assembly on a flat surface about waist high in horizontal position.
B. BACKREST
(Fig. 1)
1. To Secure The Backrest For Operation:
a) Lift backrest to upright position.
b) When secured, backrest pin will lock into place.
NOTE–
Zippie series wheelchairs are shipped with the backrest in a folded position.
C. SWING-AWAY HANGERS
1. Attaching/Removal
a) Place swing-away pivot saddle (A) into the receiver on front frame tube with the
footrest facing outward from the frame.
b) Rotate the footrest inward until it locks into place on locking bolt.
c) To remove hanger, push release latch (B) toward the frame, rotate footrest outward,
and lift.
D. ARTICULATING LEGREST
1. Attaching/Removal
a) Place swing-away pivot saddle (A) into the receiver on front frame tube with the
footrest facing outward from the frame.
b) Rotate the footrest inward until it locks into place on locking bolt.
c) To remove hanger, push release latch (B) toward the frame, rotate footrest outward,
and lift.
2. Elevating
a) To raise legrest, lift to desired position. Legrest will automatically lock in place.
b) To lower legrest, while seated in chair hold lever (C) down, lower legrest to desired
position, then release lever. Legrest will automatically lock in place.
E. ELEVATING AND 90º ELEVATING LEGRESTS
(Fig. 4, 5)
1. Attaching/Removal
a) Place swing-away pivot saddle (A) into the receiver on front frame tube with the
footrest facing outward from the frame.
b) Rotate the footrest inward until it locks into place on locking bolt.
c) To remove hanger, push release latch (B) toward the frame, rotate footrest outward,
and lift.
2. Elevating
a) To raise legrest, lift to desired position. Legrest will automatically lock in place.
b) To lower legrest, while seated in chair hold lever (C) down, lower legrest to desired
position, then release lever. Legrest will automatically lock in place.
F. COMPOSITE FOOTPLATE
1. Height Adjustment
a) Remove retaining bolts in the frame tube (A).
b) Slide footplate and extension tubes to desired height.
c) Left and right footrest will normally be at equal height.
d) Replace and tighten bolts.
(60º, 70º, or 90º) (Fig. 2)
(optional) (Fig. 3)
(optional)
(Fig. 6)
13
I X . S E T- U P A N D A D J U S T M E N T
Folded Backrest
B
A
Swing-away Hangers
C
A
B
Articulating Legrest
Elevating Legrest
C
90º Elevating Legrest

Composite Footplate

1
Upright Backrest
2
3
4
A
C
B
5
A
B
6
A
XXXXXXX Rev. A