Flip-Up Armrest; Adjustable Locking Flip-Up Armrest (Optional) - Sunrise Medical Zippie TS Owner's Manual

E N G L I S H
K. FLIP-UP ARMRESTS
1. Adjustment
Flip-up armrests are height adjustable (3") by moving the armrest assemblies up or down in
the pre-drilled holes on the backrest frame tubes.
a) To adjust armrest upward and downward, loosen cam adjustment bolt (A).
b) Rotate armrest to desired position.
c) Replace and tighten bolt.
L. ADJUSTABLE LOCKING FLIP-UP ARMREST
(Fig. 13)
1. Height Adjustment
a) Remove the hex nuts from the armrest (A) and angle adjustment plate (B) to release
the armrest and plate.
b) Release the bolts from the arm mount (C).
c) Move mount up or down the back post in 1-inch increments for desired height, or
within the arm mount holes for 1/4"inch increments.
d) Replace and tighten nuts and bolts.
2. Angle Adjustment
a) Loosen the hex nut from the angle adjustment plate (B).
b) Tilt the armrest and plate to the desired angle.
c) Tighten nut.
M. HEIGHT-ADJUSTABLE ARMRESTS
1. Installation
a) Slide the outer armpost into the receiver mounted to the wheelchair frame.
b) The armrest should lock in place automatically.
2. Removing Armrest
a) Press release lever (A) and remove the armrest.
NOTE–
Release lever should move freely. Do not force or over rotate.
3. Height Adjustment
a) Rotate release lever (A) to second stop.
NOTE– Release lever should move freely. Do not force.
b) Slide armrest pad up or down.
c) Return lever to locked position against armpost.
d) Push arm pad until upper armpost locks firmly into place.
e) A snap lock is engaged if the armrest is raised to its highest adjustment. To disconnect
the snap lock, press in on the button head and press the armrest down.
4. Replacing Armrest
a) Slide armrest back into receiver until it stops.
NOTE– Check to make sure release lever is engaged by pulling up on armrest.
5. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the receiver:
a) Loosen the four bolts on the side of the receiver.
b) With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c) Tighten the four bolts.
6. Adjusting Inner Armpost Fit
a) Two set screws (C) are installed in the outer armpost.
b) Turn the set screws in or out until the desired fit is achieved.
(Fig. 12)
(optional) (Fig. 14)
(optional)
Adjustable Locking Flip-up Armrest
15
A

Flip-up Armrest

C
B
A
A
B
C
Height Adjustable Armrest
I X .
12
13
14
XXXXXXX Rev. A