Armrest Receiver Attachment; Flip-Up Armrests; Adjustable Locking Flip-Up Armrest; T-Post Armrest - Sunrise Medical Zippie TS Manual

Z IPPI E T S
I. ARMREST RECEIVER ATTACHMENT
1. Mounting
1. Thread the two screws and washers (A) through the rear side frame tube, and into the single post
height-adjustable armrest receiver (B).
2. Tighten the hardware to 13.6 Nm [120 in-lbs].
2. Adjustment
1. To adjust the fit of the Single Post Armrest in the receiver, loosen the 4 hex bolts (C) by using a 7/16-
in wrench.
2. With the armrest assembly in the receiver (B), press firmly on the outside of the receiver.
3. Maintain pressure on the receiver and re-tighten two of the hex bolts (C).
4. Remove the armrest assembly and re-tighten the remaining two hex bolts.
5. The armrest should fit firmly into the receiver and lessen any noise that may result from vibration.
NOTE– Armrest Receiver may share hardware with wheel lock assembly if required.
J. FLIP-UP ARMRESTS
Adjustment
Flip-up armrests are height adjustable (3-in) by moving the armrest assemblies up or down in the pre-drilled
holes on the backrest frame tubes.
a. To adjust armrest upward and downward, loosen cam adjustment bolt (D).
b. Rotate armrest to desired position.
c. Replace and tighten bolt.
K. ADJUSTABLE LOCKING FLIP-UP ARMREST
1. Height Adjustment
a. Remove the hex nuts from the armrest (E) and angle adjustment plate (F) to release the armrest and
plate.
b. Release the screws from the arm mount.
c. Move mount up or down the back post in 1-in increments for desired height, or within the arm mount
holes for 1/4-in increments.
d. Replace and tighten nuts and bolts.
2. Angle Adjustment
a. Loosen the hex nut from the angle adjustment plate (G).
b. Tilt the armrest and plate to the desired angle.
c. Tighten nut.
L. T-POST ARMREST
1. Lateral Adjustment
a. Remove the receiver bolts (H).
b. Move the Receiver ( I ) forward or back to the desired position.
c. Tighten the hardware to 13.6 Nm [120 in-lbs].
2. Height Adjustment
a. Remove the screws for the Kids Arm Stop ( J ).
b. Using one of the three preset holes in armrest post, adjust to the preferred height.
c. Replace and tighten hardware. to 13.6 Nm [120 in-lbs].
NOTE – Armrest Receiver may share hardware with wheel lock assembly if required.
MK-100208 RevB
36
37
39
IX. DEALER SERVICE AND ADJUSTMENT
38
23
36
A
37
38
G