J-Bert M8040A Mipi® M-Phy Generator; Bit-3000 Dsga Mipi® M-Phy Generator - Keysight MIPI M-PHY User Manual

5 Using the Software
J-BERT M8040A MIPI
BIT-3000 DSGA MIPI
26
M-PHY Generator
®
With the M8040A it is possible to test two receiver channels of the DUT
simultaneously if you set Channels to 2. The Connection Diagram will
indicate the connections needed. Channel 1 is marked by yellow and
channel 2 by green.
If the instruments are online, i.e., Offline Connection is set to OFF, you can
specify the connection of the software to the M8040A, that is, how it is
addressed.
If Simple is checked, type in the Host IP address and the HiSLIP, the
connection protocol over the IP address.
If Advanced is checked, specify the Instrument address using TCP/IP.
As described in the section
BIT-3000 DSGA can be added to the setup. Set Low speed analyzer
(DSGA) to ON and specify the DSGA address. If the DUT has a reset and it
is to be used, set DSGA Trigger to ON.
Finally, there is the possibility to use results of level calibrations run in
ValiFrame.
Click Connect (see Figure
M-PHY Generator
®
If the instruments are online, i.e., Offline Connection is set to OFF, you can
specify the connection of the software to the BIT-3000. See
Connection Diagram will indicate the connections needed.
Specify the DSGA address using TCP/IP.
Finally, click Connect to finish configuring the setup.
Frame Generator Setups
5) to finish configuring the setup.
Keysight MIPI M-PHY Frame Generator User Guide
on page 10, a
Figure 6. The