Setting Up The Instruments - Keysight MIPI M-PHY User Manual

2 Test Instrument Setup

Setting Up the Instruments

14
Before using the connection part of the MIPI M-PHY Frame Generator
software, set up the test instruments and the DUT and establish the
required connections between them.
• Connect the instruments to the controller PC by LAN.
• Establish all required cable connections between the instruments and
the DUT.
• Switch on the PC and instruments.
• Start the Keysight IO VISA Connection Expert and check the
connections for the instruments. The use of the Connection Expert is
described in the N5991 Getting Started
• Set the correct IP addresses of the instruments.
Guide.
Keysight MIPI M-PHY Frame Generator User Guide