ETC Irideon WLZ User Manual page 12

5. Connect the
building ground
wire to the power
block on the
fixture.
6. Following the
label on the
mounting plate,
attach the power
wires to the power
block.
Install the
Mounting Plate and Complete the Wiring
(DMX Variant)
8
DMX
termination
board
Power
block
Cover plate
1.
(if needed
for surface-
mounting)
Mounting
plate
Mounting
plate bolts
Canopy
bolts
Secure the mounting plate (or
the combination of mounting
plate and cover plate for
surface-mounting) to the
installed back box, positioning
the plate so that the power side
and data side are separated by
the voltage barrier in the back
box. See Install the Voltage
Barrier (DMX Variant) on
page 5
.
Irideon WLZ User Manual