Table of Contents
Advertisement
7-26. Connecting Cord
Preparation
Refer to "7-2. Flow Chart".
Removal
1.
Loosen the two screws, and then disconnect the connecting cord.
2.
Open the four clamps.
3.
Remove the screw, and then remove the CP cable cover.
4.
Open the edge clamper and pull out the connecting cord through the hole of the sub-panel.
Edge clamper
B3 x 6
CP cable cover
Front
Clamps
Clamp
Connecting cord
Connecting
cord
Two screws
KY-656/KY-795 board
Sub-panel
149
Advertisement
Table of Contents
