Table of Contents
Advertisement
1-4. Power Supply
1-5. Installing the Option Boards
1-4. Power Supply
1-4-1. Information for Power Supply
A switching regulator is used for the power supply of this
unit. Voltage within the range of 100 V to 240 V can be
used without changing the supply voltage.
Power supply voltage :
Power supply frequency :
Power consumption :
Inrush current (peak current) : 29 A (AC 100 V)
1-4-2. Power Cord
w
. Use the specified power cord only
. Otherwise, fire or electric shock may occur.
w
. Do not damage the power cord.
. Otherwise, fire or electric shock may occur.
c
. Ground the unit safety.
. Otherwise, electric shock may occur.
Recommended parts
For customers in U.S.A. and Canada.
1 Power cord : ! 1-557-377-11
2 Plug holder :
2-990-242-01
1
For customers in the United Kingdom.
1 Power cord : ! 1-782-929-11
2 Plug holder :
3-613-640-01
Safety earth (Green/Yellow)
1
Live (Brown)
Neutral (Blue)
1-4 (E)
AC 100 to 240 V
50/60 Hz
550 W (continuous rating)
69 A (AC 240 V)
AC inlet
2
(MAV)
AC inlet
(MAV)
2
1-5. Installing the Option Boards
Installing the BKMA-540
n
. For all the procedures before starting installing the
BKMA-540, refer to the BKMA-540 Installation
Manual.
. Among the cables that are supplied with the BKMA-540,
the four cables of YEL, ORG, BLK and RED cables are
used. (The BLU cable is used for installation of MAV-
555.)
1. Open the harness clamper 1.
2. Cut the re-usable band as shown in the illustration.
n
When cutting the re-usable band, be very careful not to
damage nor cut the cables.
3. While pushing the stopper of the re-usable band in the
direction of the arrow A, remove it in the direction of
arrow B through the hole of the chassis.
n
The re-usable band that is removed in the above step,
cannot be used again. Discard it.
Re-usable band
Stopper
Cut here
Band portion
B
Hole of the
chassis
Harness clamper 2
Harness clamper 1
A
Cables
MAV-555A
Advertisement
Table of Contents
