Output Sequence Editor; Require Output Sequence - Hand Held Products 2020/5620 System Manual

3. Length
Specify what length (up to 9999 characters) of data output will be acceptable
for this symbology. Scan the four digit data length from the
Chart inside the back cover of this manual. (Note: 50 characters is entered
as 0050. 9999 is a universal number, indicating all lengths.) When calculat-
ing the length, you must count any programmed prefixes, suffixes, or format-
ted characters as part of the length (unless using 9999).
4. Character Match Sequences
On the ASCII Conversion Chart (Code Page
value that represents the character(s) you want to match. Use the
ming Chart inside the back cover of this manual to read the alphanumeric
combination that represents the ASCII characters. (99 is the Universal num-
ber, indicating all characters.)
5. End Output Sequence Editor
Scan F F to enter an Output Sequence for an additional symbology, or Save
to save your entries.
Other Programming Selections
• Discard
This exits without saving any Output Sequence changes.

Output Sequence Editor

Enter Sequence

Require Output Sequence

When an output sequence is Required , all output data must conform to an edited
sequence or the scanner will not transmit the output data to the host device.
When it's On/Not Required , the scanner will attempt to get the output data to
conform to an edited sequence, but if it cannot, the scanner transmits all output
data to the host device as is.
IMAGETEAM™ 2020/5620 System Manual
Programming
1252), page A-2, find the Hex
Default Sequence
Program-
3 - 9