Wand Emulation Plug & Play - Hand Held Products 2020/5620 System Manual

Wand Emulation Plug & Play
In Wand Emulation mode, the imager decodes the bar code then sends data in
the same format as a wand imager. The Code 39 Format converts all
symbologies to Code 39.
The Same Code Format transmits UPC, EAN, Code 128 and Interleaved 2 of 5
without any changes, but converts all other symbologies to Code 39.
The Wand Emulation Plug & Play Code 39 Format bar code below sets the
terminal ID to 61. The Wand Emulation Plug & Play Same Code Format bar
code sets the terminal ID to 64. These Plug & Play bar codes also set the
Transmission Rate to 25 inches per second, Output Polarity to black high, and
Idle State to high. (If you want to change the terminal ID only , without changing
any other imager settings, please refer to Terminal ID on page 2-1.)
Wand Emulation (Code 39 Format)
Wand Emulation Same Code
1 - 16 IMAGETEAM™ 2020/5620 System Manual